W M BERG ANODIZED ALUMINUM LINEAR SHAFT / BALL BEARING HANGER 13 MM BORE PILLOW

Description

DRAWER 119
THESE ARE EACH FROM A MOTION DISTRIBUTOR IN THE REAL WORLD !
WE HAVE 2 OTHER STYLES OF THESE FOR SALE IN OUR STORE !
BUY IT NOW IS FOR ONE HANGER ONLY
13 MM BORE AND (8)  M 3 TAPPED HOLES TO MOUNT TO YOUR PROJECT. THESE ARE EASILY DRILLED OUT TO ACCEPT A 6-32 OR 8-32 FASTENER IF YOU PREFER FRACTIONAL HARDWARE.
IF YOU PAY BY NOON EASTERN TIME I WILL MAIL YOUR ITEM THE VERY SAME DAY ! !
W. M. BERG LINEAR SHAFT / BALL BEARING HANGER FOR PROTOTYPING OR EXPERIMENTATION. THESE ARE ALSO USED TO MOUNT LINEAR SHAFTS OR SHAFTING.
THESE ARE ALMOST ALWAYS USED IN PAIRS TO SUPPORT LINEAR SHAFT OR BALL BEARINGS TO HOLD A ROTATING SHAFT.
( WE USED A 6 X 13 X 4 MM BEARING TO HOLD THE 6 MM SHAFT FOR THE PICTURES.)
IF USING TO HOLD LINEAR SHAFT YOU MAY NEED TO DRILL AND TAP THREADS TO INSTALL A SET SCREW TO PINCH THE SHAFT IN THE BORE. (8-32 SET SCREW RECOMMENDED)
LOOK CLOSELY AT THE PICTURES AND YOU WILL SEE A INTERNAL GROOVE TO ACCEPT A SNAP RING.  THIS IS USED TO PREVENT A BEARING OR SHAFT FROM POKING OUT THE OTHER SIDE OF THE HANGER. IF YOU USE A FLANGE BEARING IT IS NOT NEEDED.
WE PUT SOME EFFORT INTO THE PICTURES TO ILLUSTRATE HOW THESE CAN BE USED. WE ALSO INCLUDED A SHOT OF IT MOUNTED TO AN OLD SCHOOL MECHANICAL PROTOTYPING BREADBOARD.
PLEASE NOTE THAT THE BUY IT NOW IS FOR ONE HANGER ONLY AND IT DOES NOT COME WITH THE HARDWARE, BREADBOARD, BALL BEARING, SHAFT OR THE SNAP RING.  YOU SUPPLY THE HARDWARE  BECAUSE EVERY PROJECT WILL REQUIRE A  DIFFERENT COMBINATION OF SIZES FOR MOUNTING.
ALL OF THE OTHER ITEMS IN THE PICTURES ARE USED FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT PART OF THE SALE.